Cisco Implementing Cisco SD-WAN Solutions (300-415日本語版) follows objectives published by Cisco, so preparation should stay aligned with the official outline. PracticeVCE organizes 300-415日本語 practice questions around those exam areas to support focused review.
Choose Your 300-415日本語 Study Format
- Printable PDF: prepared by experts, available for instant download, suitable for study anywhere, and supported by 365 days of free updates.
- Desktop Test Engine: installable Windows software with two practice modes, offline access, and an environment that simulates the exam experience.
- Online Test Engine: instant access through major web browsers on Windows, Mac, Android, and iOS, with test history and performance review.
Order Support from PracticeVCE
- Security and privacy protection backed by McAfee.
- A free PDF demo is available so you can review the format and quality before purchasing.
- Every purchase includes 365 days of free updates, with renewal available at a 50% discount after expiration.
- Products are delivered by instant download and by email within one minute after payment. Contact customer support if the message does not arrive within two hours.
- There is no restriction on the number of computers where the product can be installed.
Cisco 300-415日本語 Exam Syllabus Topics:
| Section | Objectives |
|---|---|
| SD-WAN Architecture | - Cisco SD-WAN components and control plane architecture
|
| Deployment and Onboarding | - Device onboarding and provisioning
|
| Quality of Service (QoS) | - Traffic prioritization and QoS policies
|
| Routing and Connectivity | - Routing in SD-WAN environments
|
| Management and Troubleshooting | - Monitoring and operations
|
| Policies and Traffic Engineering | - Centralized policy configuration
|
| Security and Segmentation | - SD-WAN security features
|
Cisco Implementing Cisco SD-WAN Solutions (300-415日本語版): Frequently Asked Questions
The 300-415日本語 exam leads to the Cisco Certified Network Professional (CCNP) Enterprise certification from Cisco. It is positioned at the Professional level. The exam validates the knowledge and skills expected of candidates preparing for Cisco Implementing Cisco SD-WAN Solutions (300-415日本語版).
Related certifications include:
- CCNP Enterprise
- Cisco SD-WAN Specialist
The 300-415日本語 exam includes Approximately 55–65 questions and allows 120 minutes. Before test day, divide the available time by the number of questions in a timed practice set to establish a steady per-question pace. If a difficult item starts consuming too much time, mark it for review and move forward instead of losing momentum. A full timed practice session can help you decide when to move on, when to return, and how much buffer to reserve for a final check.
The passing score for 300-415日本語 is Variable (scaled score, typically ~750/1000), and the official exam fee is USD 300. Because a retake requires paying the exam fee again, use timed practice results as a readiness check before scheduling your next attempt. If your performance remains inconsistent, continue reviewing weak domains and repeat a timed session before booking the exam.
Recommended: CCNA-level knowledge. Strongly recommended: CCNP Enterprise Core (350-401 ENCOR) or equivalent networking experience.
Eligibility rules can change, so confirm the current requirements on the official exam page before registering.
You can register through the official channels listed below:
The available exam delivery method is Online proctored exam or authorized Pearson VUE testing center.
The official training options include:
- Cisco Learning Network: ENSDWI Official Training
- Implementing Cisco SD-WAN Solutions (ENSDWI) Course
After reviewing the recommended training, reinforce what you learned with PracticeVCE's 473 practice questions for 300-415日本語.
Yes. PracticeVCE provides a free PDF demo so you can review the format, question style, and answer quality before placing an order. Your purchase includes 365 days of free updates, and expired products can receive continued update service at a 50% discount.
If you purchase the corresponding 300-415日本語 preparation material and do not pass that exam within 60 days of purchase, you may apply for a full refund under the 100% Money Back Guarantee. The request requires a scanned exam enrollment slip and the official Score Report PDF, submitted within two days after the exam. Eligible requests are processed within seven days.
Claims are not eligible if the exam was taken within three days of purchase, the product was downloaded without an exam attempt, the order was free or expired, or the candidate name does not match the payer name. If you prefer an exchange instead of a refund, you can receive two free products of equal value while keeping the update service for your original purchase.
Delivery is immediate after checkout. The download is available right away, and the product is also sent to your email within one minute. Contact customer support if it has not arrived within two hours. You may install the product on an unlimited number of computers.
The current 300-415日本語 outline is organized into 7 top-level domains. The first listed areas include:
- Quality of Service (QoS)
- Management and Troubleshooting
- Security and Segmentation
Review the Exam Topics section above for the complete outline and any nested subtopics.
Cisco Implementing Cisco SD-WAN Solutions (300-415日本語版) Sample Questions:
エンジニアは、HTTP トラフィックの損失率が 10% 未満の場合はすべての HTTP トラフィックがパブリック インターネット回線を使用するように、またそれ以外の場合は MPLS を使用するように、サイト上で集中管理ポリシーを設定する必要があります。この要件を満たす構成ウィザードはどれですか?
- A. VPNメンバーシップの設定 > サイトとVPNへのポリシーの適用
- B. 関心のあるアプリケーションまたはグループを作成する > トラフィックデータを構成する > サイトとVPNにポリシーを適用する
- C. 関心のあるアプリケーションまたはグループを作成する > トラフィックルールを設定する > サイトとVPNにポリシーを適用する
- D. トポロジーの設定 > サイトとVPNへのポリシーの適用
Correct Answer: C 🗳️

「VPN 1 に直接インターネットアクセスを設定する構成はどれですか?」の図を参照してください。

- A. オプションC
- B. オプションB
- C. オプションA
Correct Answer: A 🗳️
これらの目標を達成するために、トポロジーに応じて顧客ごとに個別のVRFを設定します。

R1



R2



SW1


SW2


SW3






Correct Answer:
See the solution below in Explanation.
Explanation:
Solution:
Use cu-red under interfaces facing SW1 & SW3:
On R1:
interface Ethernet0/0
ip vrf forwarding cu-red
ip address 192.168.1.254 255.255.255.0
Check reachability to SW1:
R1#ping vrf cu-red 192.168.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.2.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
On R2:
interface Ethernet0/0
ip vrf forwarding cu-red
ip address 192.168.2.254 255.255.255.0
Check reachability to SW3:
R2#ping vrf cu-red 192.168.2.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
!!!!!
Use vrf cu-green for SW2 & SW4:
On R1:
interface Ethernet0/1
ip vrf forwarding cu-green
ip address 192.168.20.254 255.255.255.0
Test reachability to SW2:
R1#ping vrf cu-green 192.168.20.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.22.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
On R2:
interface Ethernet0/1
ip vrf forwarding cu-green
ip address 192.168.22.254 255.255.255.0
Test reachability to SW4:
R2#ping vrf cu-green 192.168.22.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.20.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
On R1:
interface Ethernet0/2.100
mpls ip
!
interface Ethernet0/2.200
mpls ip
!
Configure BGP:
router bgp 65000
neighbor 10.10.10.2 remote-as 65000
neighbor 10.10.20.2 remote-as 65000
!
address-family vpnv4
neighbor 10.10.10.2 activate
neighbor 10.10.20.2 activate
exit-address-family
!
address-family ipv4 vrf cu-green
redistribute connected
exit-address-family
!
address-family ipv4 vrf cu-red
redistribute connected
exit-address-family
!
R1(config)#ip vrf cu-red
R1(config-vrf)#route-target both 65000:100
!
R1(config)#ip vrf cu-green
R1(config-vrf)#route-target both 65000:200
On R2:
interface Ethernet0/2.100
mpls ip
!
interface Ethernet0/2.200
mpls ip
!
router bgp 65000
neighbor 10.10.10.1 remote-as 65000
neighbor 10.10.20.1 remote-as 65000
!
address-family vpnv4
neighbor 10.10.10.1 activate
neighbor 10.10.20.1 activate
exit-address-family
!
address-family ipv4 vrf cu-green
redistribute connected
exit-address-family
!
address-family ipv4 vrf cu-red
redistribute connected
exit-address-family
R2(config)#ip vrf cu-red
R2(config-vrf)#route-target both 65000:100
!
R2(config)#ip vrf cu-green
R2(config-vrf)#route-target both 65000:200
Verification:
From SW1 to SW3:
SW1#ping 192.168.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
But can't Reach SW2 or SW4 in VRF cu-green:
SW1#ping 192.168.22.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.22.1, timeout is 2 seconds:
U.U.U
Success rate is 0 percent (0/5)
SW1#ping 192.168.20.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.20.1, timeout is 2 seconds:
U.U.U
Success rate is 0 percent (0/5)
Same Test for SW2:
From SW2 to SW4:
SW2#ping 192.168.20.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.20.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
But can't Reach SW3 or SW1 in VRF cu-red:
SW2#ping 192.168.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
U.U.U
Success rate is 0 percent (0/5)
SW2#ping 192.168.2.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.2.1, timeout is 2 seconds:
U.U.U
Success rate is 0 percent (0/5)
Both R1 & R2 has separate tables for VRFs cu-red and cu-green.
Cisco SD-WANコントローラでは、カスタムアプリケーションポートはどのように監視されますか?
- A. お客様は、vAnalytics および vSmart にカスタム アプリケーション ポートを追加します。
- B. CiscoはvAnalyticsとvManageにカスタムアプリケーションポートを追加しました。
- C. CiscoがvAnalyticsとvSmartにカスタムアプリケーションポートを追加。
- D. お客様は、vAnalytics および vManage にカスタム アプリケーション ポートを追加します。
Correct Answer: D 🗳️
添付資料を参照してください。
エンジニアが、有効な証明書シリアル番号が入力されているにもかかわらず、制御接続が切断される問題のトラブルシューティングを行っています。この問題を解決するには、どの2つの操作を実行すればよいでしょうか?(2つ選択してください)
- A. ネットワーク内の重複IPを削除します。
- B. コントローラのネットワーク接続性を復元する
- C. PNPポータルで有効な製品ID(モデル)を入力してください
- D. 指定されたデバイスのコントローラーに有効なシリアル番号を入力してください
- E. コントローラー間でシリアル番号ファイルを照合する
Correct Answer: C,E 🗳️
Explanation: Only visible for PracticeVCE members. You can sign-up / login (it's free).
Viewing page 1 out of 95 pages.
Viewing questions 1-5 out of 473 questions.

0 Customer Reviews